SuperSieve Pump (Pump fed only)

£400.00

SKU: PF0521 Category:

The SuperSieve pump uses special industrial curved screens. A curved screen is made up of knife-sharp triangular rods which are angled in relation to one another and incorporate a slit of 300 microns (0.3 mm). The water runs up against the sharp edge of the triangle, breaking the surface tension of the water. The dirt particles are then pushed away from the screen element and lifted out of the water. Then the dirt slides further down the screen element. This dirt collects in the SuperSieve’s dirt gutter. The dirt can now no longer contaminate the water by dissolving in it. Neither do bacteria have any chance of converting this trapped dirt into ammonia, nitrite or nitrate, which also extracts a lot of oxygen out of the water.

– Removes floating particles/dirt particles down to 300 microns
– Removes dirt right out of the water and onto dry land
– Small dimensions (lxwxh = 42x39x60)
– Up to 20m3/hour
– Large return connections
– Inc. dirt discharge gutter
– Inc. lid
– Large screen element (32cm wide/47cm long)
– 2×75/110mm outlet
– 2x 63mm inlet
– 2x 75mm overflow protection
– 2x 63mm dirt discharge
– Connections on both sides

The SuperSieve pump is characterised by an ingenious design. It’s construction allows connections to be fitted to both sides. The SuperSieve is made up of 2 parts:
– The pre-chamber into which the water is pumped
– The chamber where the screen element is located

The closed pre-chamber ‘pushes’ the water at right angles to the screen element. This improves dirt separation and increases the flow through the screen element. The water passes through the curved screen above the element so that water does not mix with dirt that has already been separated out.

The screen element is sealed with specially manufactured rubbers on the housing so that no water (and thus no dirt) can pass through the screen element unfiltered. The housing comes with a  lid to reduce the noise and slow down the growth of algae and bacteria on the screen element.

The housing has the following connections: an overflow protection, a dirt gutter with discharge and two 110mm discharges.

The SuperSieve pump thus processes a good 20m3/hour with two 110mm outlets.

Dimensions (cm): 42 x 39 x 60
Casing Material: Plastic
Max. m³/hour: 25
Overflow protection (mm): 2x 75
Inlet (mm): 2x 63
Outlet (mm): 2x 75/110
Dirt Discharge (mm): 2x 63

Reviews

There are no reviews yet.

Be the first to review “SuperSieve Pump (Pump fed only)”

Your email address will not be published. Required fields are marked *